Map Light Assembly: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE MAP LIGHT ASSEMBLY
1. Using a screwdriver, detach the 2 claws and 2 covers.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Identifying Map Light Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws.
  
  Fig 2: Locating Map Light Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a moulding remover, detach the 2 clips.
4. Disconnect the connectors and remove the map light.
Fig 3: Identifying Map Light Connectors And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002