Terminals Of Ecu

Fig 1: Identifying Television Camera Assembly Connector S35

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the S35 camera connector.
2. Measure the voltage and resistance according to the value(s) in the table below.
   CONNECTOR TERMINAL REFERENCE
   
   

   Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
   S35-3 (CGND) - Body ground	R - Body ground	Ground	Always	Below 1 Ω
   S35-4 (CB+) - S35-3 (CGND)	B - R	Power source	Engine switch on (IG), shift lever R position	5.8 to 6.5 V

   If the result is not as specified, there may be a malfunction on the wire harness side.

3. Reconnect the S35 camera connector.
4. Measure the waveform according to the value(s) in the table below.
   CONNECTOR TERMINAL REFERENCE
   
   

   Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
   S35-2 (CV+) - S35-1 (CV-)	W - Shielded	Display signal	Engine switch on (IG), shift lever R position	See  ewaveform 1

   If the result is not as specified, the camera may have a malfunction.

5. Using an oscilloscope, check waveform 1.

Waveform 1 (Reference) 

Fig 2: Waveform Graph

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002