Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / ECT / Data List.
5. Read the value displayed on the Techstream.
6. Crank the engine.
7. Read the value displayed on the Techstream.

   OK 

   STANDARD CONDITION CHART
   
   

   Tester Display	Condition	Standard
   Starter Signal	Engine switch on (IG)	OFF
   Starter Signal	Engine Is cranking	ON

NG: Go to step  4

OK: Go to Next Step 

1. Disconnect the A12 and E5 TCM connectors.
2. Measure the voltage of the wire harness side connectors.

   Standard Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   A12-3 (STA) - E5-7 (E1)	Always	Below 2 V

   Fig 1: Identifying A12 And E5 TCM Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - ST RELAY) 

OK: Go to Next Step 

1. Replace the TCM (see REMOVAL  ).

NEXT: PERFORM A/T CODE REGISTRATION  (See REGISTRATION  )

1. Disconnect the E49 park/neutral position switch connector.
2. Measure the resistance of the park/neutral position switch when the shift lever is moved to each position.

   Standard Resistance 

   RESISTANCE REFERENCE
   
   

   Tester Connection	Condition	Specified Condition
   4 (B) - 5 (L)	Shift lever on P	Below 1 Ω
   4 (B) - 5 (L)	Shift lever on N	Below 1 Ω

   Fig 2: Identifying Park/Neutral Position Switch Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE PARK/NEUTRAL POSITION SWITCH  (See REMOVAL  )

OK: CHECK CRANKING HOLDING FUNCTION CIRCUIT  (See CRANKING HOLDING FUNCTION CIRCUIT )