Front Door Lock: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See
PRECAUTION
).
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See
INITIALIZATION
).
- REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
(See
DISASSEMBLY
)
- REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
(See
DISASSEMBLY
)
- REMOVE COURTESY LIGHT ASSEMBLY
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR TRIM COVER
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR SERVICE HOLE COVER
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR OUTSIDE HANDLE COVER
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
(See
DISASSEMBLY
)
- REMOVE FRONT NO. 1 DOOR STIFFENER CUSHION
(See
DISASSEMBLY
)
- REMOVE FRONT DOOR LOCK ASSEMBLY
- Disconnect the connector
- Using a "TORX" socket wrench (T30), remove the 3 screws
- Slide the front door lock assembly downward, pull out the front door lock open rod from the front door outside handle frame, and remove the front door lock assembly and cables as a unit
- Remove the front door lock open rod from the front door lock assembly
- Remove the door lock wiring harness seal from the front door lock assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
- Remove the front door lock remote control cable assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
- Using a screwdriver, disengage the 3 claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Remove the front door inside locking cable assembly