Inspection Procedure

1. Drive the vehicle and check if the function of the speedometer in the combination meter is normal.

   OK: Actual vehicle speed and the speed indicated on the speedometer are the same. 

   HINT.

   The vehicle speed sensor is functioning normally when the indication on the speedometer is normal

NG: GO TO METER / GAUGE SYSTEM  (See PROBLEM SYMPTOMS TABLE )

OK: Go to Next Step 

1. Disconnect the multi-display connector
2. Measure voltage.
   1. Jack up either one of the drive wheels
   2. Move the shift lever to N.
   3. Turn the engine switch on (IG)
      Fig 1: Identifying Terminals Of Multi-Display Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Measure the voltage between terminal SPD of the multi-display and body ground when the drive wheels are turned slowly

      OK: Voltage pulses as shown in the illustration. 

   Fig 2: Identifying Voltage Blinking Pattern

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: Go to step 3 

OK: REPLACE MULTI-DISPLAY  (See REMOVAL  )

1. Disconnect the multi-display connector and combination meter connector.
   Fig 3: Identifying Terminals Of Multi-Display Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below

   Standard Resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Switch Condition	Specified Condition
   J50-14 (SPD) - J34-5 (+S)	Engine switch off	Below 1 Ω

Fig 4: Identifying Terminals Of Combination Meter Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to Next Step 

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Switch Condition	Specified Condition
   J50-14 (SPD) - Body ground	Engine switch off	10 kΩ or higher

   HINT

   If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or an ECU that is connected to the SPD signal wire.

   Fig 5: Identifying Terminals Of Multi-Display Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU 

OK: REPLACE COMBINATION METER  (See REMOVAL )