Amplifier Antenna: Installation

INSTALL AMPLIFIER ANTENNA ASSEMBLY
1. Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.
  NOTE:
  - Clean the antenna conductors on the rear window with a non-residue solvent where the contact terminals will touch.
  - When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.
  - Do not touch the contact terminals.
    
    Fig 1: Identifying Amplifier Antenna Assembly Clip
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 nuts and amplifier antenna assembly
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 2: Identifying Amplifier Antenna Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector
4. Engage the clamp.
INSTALL ROOF HEADLINING ASSEMBLY
(See INSTALLATION )

HINT

Refer to the procedures from " 2 Install Roof Headlining Assembly"
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )