Inspection Procedure
NOTE:
When the ECM is replaced with a new one, initialization must be performed (See INSTALLATION
).
- REPLACE SKID CONTROL ECU
- Replace the skid control ECU (See SKID CONTROL ECU ).
- CHECK DTC
- Clear the DTC (See DTC CHECK / CLEAR ).
- Turn the cruise control main switch on.
- Drive the vehicle at the require speed (45 km/h (27 mph) or higher).
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC P1630 is not output A DTC P1630 is output B
B: REPLACE ECM (for 2UR-GSE) (See ECM )
A: END