LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Center Airbag Sensor Assembly >> Installation

Center Airbag Sensor Assembly: Installation

  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY 
    1. Check that the engine switch is off.
    2. Check that the battery negative (-) terminal is disconnected.
      Fig 1: Locating Bolts And Center Airbag Sensor Assembly
      G05320029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
    3. Install the center airbag sensor assembly with the nut and 2 bolts.

      Torque: 17.5 N*m (179 kgf*cm, 13 ft.*lbf) 

      NOTE:
      • If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
      • When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
      Fig 2: Locating Bolts And Center Airbag Sensor Assembly
      G05320029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Check that there is no looseness in the installation parts of the center airbag sensor assembly.
    5. Connect the holder (with connectors).
    6. Check that the water-proof sheet is properly set.
  2. INSTALL CONSOLE BOX  (See INSTALLATION )
  3. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  4. INSTALL REAR ASH RECEPTACLE ASSEMBLY 
  5. INSTALL FRONT ASH RECEPTACLE SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  (See INSTALLATION )
  7. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  (See INSTALLATION )
  8. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)  (See INSTALLATION )
  9. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission)  (See INSTALLATION )
  10. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission)  (See INSTALLATION )
  11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) 
  12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) 
  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  14. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).

      HINT:

      Some systems need initialization after reconnecting the cable to the negative battery terminal.

  15. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals