LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning >> Blower Unit >> Removal

Blower Unit: Removal

  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  2. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  3. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  4. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  5. DISCHARGE REFRIGERANT FROM REFRIGERATION 
    1. Start up the engine.
    2. Turn the A/C switch on.
    3. Operate the cooler compressor at an engine rpm of approximately 1,000 for 5 to 6 minutes to circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.
    4. Stop the engine.
    5. Using SST, let the refrigerant gas out.

      SST 09985-20010 (09985-02010, 09985-02050, 09985-02060, 09985-02070, 09985-02080, 09985-02090, 09985-02110, 09985-02130, 09985-02140, 09985-02150) 

  6. DISCONNECT CABLE FROM NEGATIVE BATTERY 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See PRECAUTION )
  7. REMOVE FRONT FENDER PROTECTOR UPPER LH  (See REMOVAL )
  8. REMOVE FRONT FENDER PROTECTOR UPPER RH  (See REMOVAL )
  9. REMOVE ROOF DRIP SIDE FINISH MOLDING LH  (See REMOVAL )
  10. REMOVE ROOF DRIP SIDE FINISH MOLDING RH  (See REMOVAL )
  11. REMOVE FRONT WIPER ARM HEAD CAP  (See REMOVAL )
  12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  13. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  14. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  15. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  16. SEPARATE SUCTION PIPE SUB-ASSEMBLY  (See REMOVAL  )
  17. SEPARATE LIQUID TUBE SUB-ASSEMBLY  (See REMOVAL  )
  18. REMOVE HEATER WATER OUTLET HOSE  (See REMOVAL  )
  19. REMOVE HEATER WATER INLET HOSE  (See REMOVAL  )
  20. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)  (See REMOVAL )
  21. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  22. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission)  (See REMOVAL )
  23. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission)  (See REMOVAL )
  24. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)  (See REMOVAL )
  25. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  26. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  27. REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY  (See REMOVAL )
  28. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  29. REMOVE CONSOLE BOX  (See REMOVAL )
  30. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  31. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL  (See REMOVAL )
  32. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Navigation System)  (See REMOVAL )
  33. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System)  (See REMOVAL )
  34. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  35. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  36. REMOVE STEERING PAD  (See REMOVAL )
  37. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  38. REMOVE STEERING COLUMN COVER (for Power Tilt and Power Telescopic)  (See REMOVAL )
  39. REMOVE STEERING COLUMN COVER (for Manual Tilt)  (See REMOVAL )
  40. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See REMOVAL )
  41. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Illumination)  (See REMOVAL )
  42. REMOVE FRONT DOOR SCUFF PLATE LH (w/ Illumination)  (See REMOVAL )
  43. REMOVE FRONT DOOR OPENING TRIM COVER LH  (See REMOVAL )
  44. REMOVE SIDE INSTRUMENT PANEL LH  (See REMOVAL )
  45. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  46. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  47. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  48. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  49. REMOVE COMBINATION METER ASSEMBLY  (See REMOVAL )
  50. REMOVE FRONT DOOR SCUFF PLATE RH (w/o Illumination)  (See REMOVAL )
  51. REMOVE FRONT DOOR SCUFF PLATE RH (w/ Illumination)  (See REMOVAL )
  52. REMOVE FRONT DOOR OPENING TRIM COVER RH  (See REMOVAL )
  53. REMOVE SIDE INSTRUMENT PANEL RH  (See REMOVAL )
  54. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  55. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  56. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (See REMOVAL )
  57. REMOVE FRONT PILLAR GARNISH LH  (See REMOVAL )
  58. REMOVE FRONT PILLAR GARNISH RH 
  59. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  60. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  61. REMOVE NO. 3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See REMOVAL )
  62. REMOVE FRONT STEREO COMPONENT SPEAKER ASSEMBLY (w/ Front Center Speaker)  (See REMOVAL )
  63. REMOVE NO. 2 CONSOLE BOX DUCT (for Automatic Transmission)  (See REMOVAL )
  64. REMOVE NO. 1 CONSOLE BOX DUCT (for Automatic Transmission)  (See REMOVAL )
  65. REMOVE NO. 2 CONSOLE BOX DUCT (for Manual Transmission)  (See REMOVAL )
  66. DISCONNECT PASSENGER AIRBAG CONNECTOR 
  67. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY  (See REMOVAL )
  68. REMOVE NO. 1 AIR DUCT  (See REMOVAL )
  69. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY (for 2WD)  (See REMOVAL )
  70. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 4WD)  (See REMOVAL )
  71. REMOVE STEERING COLUMN ASSEMBLY (for Manual Tilt)  (See REMOVAL )
  72. REMOVE STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic)  (See REMOVAL )
  73. REMOVE DEFROSTER NOZZLE LOWER ASSEMBLY  (See REMOVAL  )
  74. REMOVE IMMOBILIZER CODE ECU 
  75. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY  (See REMOVAL  )
  76. REMOVE AIR CONDITIONER UNIT ASSEMBLY  (See REMOVAL  )
  77. REMOVE NO. 2 AIR DUCT  (See REMOVAL  )
  78. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY  (See REMOVAL  )
  79. REMOVE BLOWER ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the screw.
    3. Release the 2 claws and remove the blower assembly.
      Fig 1: Identifying Blower Assembly Claw And Screw
      G05755341Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals