Valve Body Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the check ball body and spring.
  
  Fig 1: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the accumulator pistons, check ball body and spring as shown in the illustration.
  
  Fig 2: Identifying Accumulator Pistons, Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of the lever.
  
  Fig 3: Aligning Groove Of Manual Valve With Pin Of Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 19 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  Bolt length:
  
  Bolt A: 25 mm (0.98 in.)
  
  Bolt B: 36 mm (1.42 in.)
  
  Bolt C: 45 mm (1.77 in.)
  
  Bolt D: 50 mm (1.97 in.)
  
  Fig 4: Identifying Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID (See AUTOMATIC TRANSMISSION FLUID )
RESET MEMORY (See INITIALIZATION )