Amplifier Antenna: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL AMPLIFIER ANTENNA ASSEMBLY
1. Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.
  NOTE:
  - Clean the antenna conductors on the rear window with a non-residue solvent where the contact terminals will touch.
  - When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.
  - Do not touch the contact terminals.
    
    Fig 1: Identifying Amplifier Antenna Assembly Clip
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 nuts and amplifier antenna assembly
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 2: Identifying Amplifier Antenna Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector
4. Engage the clamp.
INSTALL ROOF HEADLINING ASSEMBLY
(See INSTALLATION )

HINT

Refer to the procedures from " 2 Install Roof Headlining Assembly"
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )