Section 16 (Emission Control): Canister: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CHARCOAL CANISTER ASSEMBLY
1. Install the charcoal canister assembly with the 4 nuts.
  Torque: 15 N*m (150 kgf*cm, 11 ft.*lbf)
  
  Fig 1: Locating Charcoal Canister Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 2 quick connectors, hose and connector.
  
  Fig 2: Locating Quick Connectors, Hose And Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the wire harness with the 2 clamps.
Fig 3: Locating Wire Harness Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 FLOOR UNDER COVER
1. Install the No. 1 floor under cover with the 3 nuts and 6 clips.
Fig 4: Locating No. 1 Floor Under Cover, Nuts And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).