Height Control Sensor: Installation

INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
1. When replacing the rear height control sensor sub-assembly:
  1. Align the matchmarks and also the trace of the nut, and install the rear height control sensor sub-assembly and bracket.
2. When reusing the rear height control sensor sub-assembly:
  1. Align the matchmarks on the rear height control sensor sub-assembly and bracket.
    
    Fig 1: Aligning Matchmarks On Rear Height Control Sensor Sub-Assembly And Bracket
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the rear height control sensor sub-assembly with the 2 bolts and nut.
  Torque: Bolt
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Nut
  
  5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. Install the clamp.
5. Connect the connector.
  
  Fig 2: Locating Connector And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for 4WD)
1. Install the 2 bolts.
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 3: Locating Bolts And Front Height Control Sensor Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front height control sensor sub-assembly with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Connect the connector.
  
  Fig 4: Locating Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for 2WD)
1. Install the 2 bolts.
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 5: Locating Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front height control sensor sub-assembly with the nut.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Connect the connector.
VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT (See ADJUSTMENT )
PREPARATION FOR HEADLIGHT AIMING (Using a tester) (See ADJUSTMENT )
PREPARATION FOR HEADLIGHT AIMING (Using a screen) (See ADJUSTMENT )
HEADLIGHT AIMING INSPECTION (See ADJUSTMENT )
HEADLIGHT AIMING ADJUSTMENT (See ADJUSTMENT )