Cold Start Injector: Installation

INSTALL COLD START INJECTOR
1. Install a new gasket to the intake air surge tank.
  HINT:
  
  Align the protrusion of the gasket on the intake air surge tank.
  
  Fig 1: Aligning Protrusion Of Gasket On Intake Air Surge Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the cold start injector with the 2 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Locating Cold Start Injector Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install 2 new gaskets and the hose to the cold start injector with the bolt.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  NOTE:
  - Be careful not to damage the gasket.
  - Do not fold or bend the hose.
  Fig 3: Locating Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See ON-VEHICLE INSPECTION )
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.