LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> A760H Automatic Transaxle >> Torque Converter And Drive Plate >> Installation

Torque Converter And Drive Plate: Installation

  1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY  (See INSTALLATION  )
  2. INSTALL TRANSMISSION OIL COOLER  (See INSTALLATION  )
  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER LH  (See INSTALLATION  )
  4. INSTALL TRANSFER DYNAMIC DAMPER  (See INSTALLATION  )
  5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR  (See INSTALLATION  )
  6. INSTALL AUTOMATIC WITH TRANSMISSION TRANSFER ASSEMBLY  (See INSTALLATION  )
  7. INSTALL WATER BY-PASS HOSE  (See INSTALLATION  )
  8. INSTALL WIRE HARNESS  (See INSTALLATION  )
  9. CONNECT CONNECTOR  (See INSTALLATION  )
  10. INSTALL ENGINE REAR MOUNTING MEMBER  (See INSTALLATION  )
  11. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  (See INSTALLATION  )
  12. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY  (See INSTALLATION  )
  13. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT  (See INSTALLATION  )
  14. INSTALL STARTER ASSEMBLY  (See INSTALLATION )
  15. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH  (See INSTALLATION )
  16. INSTALL FRONT PROPELLER SHAFT ASSEMBLY  (See INSTALLATION )
  17. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY  (See INSTALLATION )
  18. INSTALL OUTSIDE AIR GUIDE PLATE RH  (See INSTALLATION )
  19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  20. ADJUST SHIFT LEVER POSITION  (See ADJUSTMENT  )
  21. INSPECT SHIFT LEVER POSITION  (See ON-VEHICLE INSPECTION  )
  22. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR  (See INSTALLATION )
  23. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  24. INSTALL OXYGEN SENSOR  (See INSTALLATION )
  25. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  26. INSTALL NO. 1 REAR FLOOR PANEL BRACE  (See INSTALLATION )
  27. ADD COOLANT 

    (See ON-VEHICLE INSPECTION )

  28. ADD AUTOMATIC TRANSMISSION FLUID 

    (See ADJUSTMENT  )

  29. ADJUST COOLANT 

    (See ON-VEHICLE INSPECTION )

  30. CHECK FOR ENGINE COOLANT LEAKS  (See ON-VEHICLE INSPECTION )
  31. CHECK FOR EXHAUST GAS LEAKS  (See INSTALLATION )
  32. INSTALL ENGINE UNDER COVER 
  33. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  34. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  35. RESET MEMORY 

    (See INITIALIZATION  )

scientia non olet · About LEMON Manuals