Park / Neutral Position Switch: Installation

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
2. Temporarily install the bolt.
  
  Fig 1: Locating Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new lock washer with the lock nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Locating Lock Washer And Lock Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the neutral position.
5. Remove the transmission control shaft lever.
  
  Fig 3: Removing Transmission Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Align the neutral alignment mark line with the switch groove, and tighten the bolt.
  Torque: 13 N*m (133 kgf*cm, 9 ft.*lbf)
  
  Fig 4: Aligning Neutral Alignment Mark Line With Switch Groove
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Using a screwdriver, bend the tabs of the lock washer.
  
  Fig 5: Bending Tabs Of Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Connect the park/neutral position switch connector to the neutral start switch.
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See INSPECTION )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )