LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (A960E Automatic Transaxle) >> Torque Converter And Drive Plate >> Installation

Torque Converter And Drive Plate: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY  (See INSTALLATION )
  2. INSTALL TRANSMISSION OIL COOLER  (See INSTALLATION )
  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH  (See INSTALLATION )
  4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR  (See INSTALLATION )
  5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY  (See INSTALLATION )
  6. INSTALL WATER BY-PASS HOSE  (See INSTALLATION )
  7. INSTALL WIRE HARNESS  (See INSTALLATION )
  8. INSTALL CONNECTOR  (See INSTALLATION )
  9. INSTALL ENGINE REAR MOUNTING MEMBER  (See INSTALLATION )
  10. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  (See INSTALLATION )
  11. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY  (See INSTALLATION )
  12. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT  (See INSTALLATION )
  13. INSTALL STARTER ASSEMBLY  (See INSTALLATION )
  14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH  (See INSTALLATION )
  15. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY  (See INSTALLATION )
  16. INSTALL OUTSIDE AIR GUIDE PLATE RH  (See INSTALLATION )
  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  18. ADJUST SHIFT LEVER POSITION  (See ADJUSTMENT )
  19. INSPECT SHIFT LEVER POSITION  (See ON-VEHICLE INSPECTION )
  20. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR  (See INSTALLATION )
  21. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  22. INSTALL OXYGEN SENSOR  (See INSTALLATION )
  23. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  24. INSTALL NO. 1 REAR FLOOR PANEL BRACE  (See INSTALLATION )
  25. DRAIN ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  26. ADD AUTOMATIC TRANSMISSION FLUID  (See AUTOMATIC TRANSMISSION FLUID )
  27. ADD COOLANT  (See ON-VEHICLE INSPECTION )
  28. CHECK FOR ENGINE COOLANT LEAKS  (See ON-VEHICLE INSPECTION )
  29. CHECK FOR EXHAUST GAS LEAKS  (See INSTALLATION )
  30. INSTALL NO. 2 ENGINE UNDER COVER 
  31. INSTALL ENGINE UNDER COVER 
  32. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  33. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  34. RESET MEMORY  (See MANUAL SHIFTING TEST )
scientia non olet · About LEMON Manuals