Park / Neutral Position Switch: Removal

WARNING: This page is about a different variant/trim than selected.

SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY (See REMOVAL )
REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Disconnect the park/neutral position switch connector.
  
  Fig 1: Disconnecting Park/Neutral Position Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut and transmission control shaft lever RH.
  
  Fig 2: Locating Transmission Control Shaft Lever RH Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, pry out the lock washer.
4. Remove the lock nut and lock washer.
  
  Fig 3: Prying Out Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the bolt and park/neutral position switch.
Fig 4: Locating Park/Neutral Position Switch Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002