LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel (4GR-FSE) >> Fuel Pump Resistor >> Installation

Fuel Pump Resistor: Installation

  1. INSTALL FUEL PUMP RESISTOR 
    1. Install the fuel pump resistor with the bolt.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

    2. Install the ground wires with the 2 bolts.

      Torque: 8.0 N*m (80 kgf*cm, 69 in.*lbf) 

    3. Connect the connector with the clamp.
      4. Fig 1: Locating Bolts, Fuel Pump Resistor And Ground Wires
      G05826431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ENGINE ROOM RH SIDE COVER  (See INSTALLATION )
  3. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  5. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).

      HINT:

      Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.

scientia non olet · About LEMON Manuals