Fuel Pressure Pulsation Damper: Installation

INSTALL FUEL PRESSURE PULSATION DAMPER
1. Using SST, install 2 new gaskets, the fuel tube and pulsation damper to the fuel pump.
  SST 09612-24014 (09617-24011)
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  Fig 1: Installing Fuel Tube And Pulsation Damper To Fuel Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (See PRECAUTION ).
INSTALL V-BANK COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.