On-Vehicle Inspection

HINT:

Remove interior parts so that the front No. 1 speaker can be seen.

1. Check the speaker installation.

   OK: 

   The speaker is securely installed. If the result is not as specified, reinstall the front No. 1 speaker. 

2. Visually check the speaker.

   OK: 

   The cone paper of the speaker is not torn. 

   If the result is not as specified, replace the front No. 1 speaker.

3. Speaker resistance check
   1. Disconnect the front No. 1 speaker connector.
   2. Measure the resistance between the terminals of the speaker.

      Standard resistance: 

      Without Front Center Speaker: 

      Approximately 4 Ω 

      With Front Center Speaker: 

      6 to 10 Ω 

      If the result is not as specified, replace the front No. 1 speaker.

HINT:

Remove interior parts so that the front No. 2 speaker can be seen.

1. Check the speaker installation.

   OK: 

   The speaker is securely installed. 

   If the result is not as specified, reinstall the front No. 2 speaker.

2. Visually check the speaker.

   OK: 

   The cone paper of the speaker is not torn. 

   If the result is not as specified, replace the front No. 2 speaker.

HINT:

Remove interior parts so that the front No. 3 speaker can be seen.

1. Check the speaker installation.

   OK: 

   The speaker is securely installed. 

   If the result is not as specified, reinstall the front No. 3 speaker.

2. Visually check the speaker.

   OK: 

   The cone paper of the speaker is not torn. 

   If the result is not as specified, replace the front No. 3 speaker.