Amplifier Antenna: Installation

INSTALL AMPLIFIER ANTENNA ASSEMBLY
1. Engage the clip as shown in the illustration to temporarily install the amplifier antenna assembly.
  NOTE:
  - Clean the antenna conductors on the rear window with white gasoline where the contact terminals will touch.
  - When installing a new amplifier antenna assembly, do not remove the protective cover until immediately before installation.
  - Do not touch the contact terminals.
  Fig 1: Identifying Amplifier Antenna Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 nuts and amplifier antenna assembly.
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
3. Connect the connector.
4. Engage the clamp.
INSTALL ROOF HEADLINING ASSEMBLY
(See INSTALLATION )

HINT:

Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )