Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the CRUISE main indicator light by performing the Active Test.

   Combination Meter: 

   ACTIVE TEST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp Cruise	Turns CRUISE main indicator light	BLINK/OFF	-

   OK: Indicator light blinks/goes off. 

NG: REPLACE COMBINATION METER ASSEMBLY 

OK: Go to Next Step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Cruise Control / Data List.
5. Check the Data List for proper functioning of the CRUISE main indicator light.

   ECM (Cruise Control): 

   DATA LIST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU)/ON or OFF	ON: "CRUISE" on OFF: "CRUISE" off	-

   OK: When the cruise control main switch is operated, the display changes as shown above. 

NG: REPLACE ECM 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE