Rear Axle Shaft: Installation

INSTALL REAR AXLE SHAFT
1. Using SST and a press, install the rear axle shaft to the rear axle bearing assembly.
  SST 09521-25011
  
  NOTE: Do not damage the speed sensor rotor.
  
  Fig 1: Using SST & Press To Install Rear Axle Shaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE SHAFT SNAP RING
1. Using a snap ring expander, install a new rear axle shaft snap ring.
  
  Fig 2: Using Snap Ring Expander To Install New Rear Axle Shaft Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE SHAFT OIL SEAL
1. Using SST and a hammer, install a new axle shaft oil seal.
  SST 09950-60020 (09951-00770), 09950-70010 (09951-07150)
  
  Fig 3: Using SST & Hammer To Install New Rear Axle Shaft Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE SHAFT WITH BACKING PLATE
1. Install a new O-ring.
2. Install the rear axle shaft with backing plate with the 4 nuts.
  Torque: 120 N*m (1,224 kgf*cm, 89 ft.*lbf)
  NOTE:
  - Do not damage the speed sensor rotor.
  - Inspect no damage and no foreign matter at the speed sensor rotor.
  Fig 4: Identifying Rear Axle Shaft With Backing Plate Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL PARKING BRAKE SHOE (See REASSEMBLY )
INSTALL PARKING BRAKE SHOE STRUT
INSTALL PARKING BRAKE SHOE STRUT COMPRESSION SPRING
INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING (See REASSEMBLY )
INSTALL REAR DISC
CONNECT REAR DISC BRAKE CALIPER ASSEMBLY
HINT:

(See INSTALLATION )
INSTALL REAR SPEED SENSOR (w/ABS) (See INSTALLATION )
FILL UP DIFFERENTIAL OIL (See ADJUSTMENT )
ADD RESERVOIR WITH BRAKE FLUID
BLEED MASTER CYLINDER
BLEED BRAKE LINE
INSPECT BRAKE FLUID LEVEL IN RESERVOIR
INSPECT BRAKE FLUID LEAKAGE
INSTALL REAR WHEEL
Torque: 112 N*m (1,142 kgf*cm, 83 ft.*lbf)
INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL
HINT:

(See ADJUSTMENT )
INSPECT ABS SPEED SENSOR SIGNAL (w/ABS)
HINT:

(See TEST MODE PROCEDURE )