LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> GS 460 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1UR-FSE) - Circuit Tests And Repair Information >> Camshaft Oil Control Valve >> Installation

Camshaft Oil Control Valve: Installation

  1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2) 
    1. Apply a light coat of engine oil to a new O-ring, and install it to the oil control valve.
    2. Install the oil control valve with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • Do not allow foreign matter to contact the oil seal face of the oil control valve (connecting surface with cylinder head cover sub-assembly).
      • Make sure that the O-ring is not cracked or dose not jump out of position when installing the oil control valve.
        Fig 1: Locating Bolt And Oil Control Valve
        G05804044Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the camshaft timing oil control valve connector.
  2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1) 
    1. Apply a light coat of engine oil to a new O-ring, and install it to the oil control valve.
      Fig 2: Locating Camshaft Timing Oil Control Valve Connector
      G05804047Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the oil control valve with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • Do not allow foreign matter to contact the oil seal face of the oil control valve (connecting surface with cylinder head cover sub-assembly).
      • Make sure that the O-ring is not cracked or dose not jump out of position when installing the oil control valve.
        Fig 3: Locating Bolt And Oil Control Valve
        G05804042Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the camshaft timing oil control valve connector.
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  5. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
    Fig 4: Locating Camshaft Timing Oil Control Valve Connector
    G05804041Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  7. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  8. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
scientia non olet · About LEMON Manuals