Navigation Ecu: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart. (See SPECIFIED TORQUE FOR STANDARD BOLTS )

Fig 1: Locating No. 1 Disc Player Bracket Screws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. INSTALL NO. 2 DISC PLAYER BRACKET 
   1. Install the bracket's aligning protrusions labeled A to the ECU.
   2. Install the 2 screws labeled B.
      Fig 2: Locating No. 2 Disc Player Bracket Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 1 DISC PLAYER BRACKET 
   1. Install the bracket's aligning protrusions labeled A to the ECU.
   2. Install the 2 screws labeled B.
      Fig 3: Locating No. 1 Disc Player Bracket Screw

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL NAVIGATION ECU WITH DISC PLAYER BRACKET 
   1. Install the navigation ECU with bracket with the 3 bolts.
   2. Connect the connectors.
4. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY  (See INSTALLATION )
5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
7. INSTALL INSTRUMENT SIDE PANEL RH  (See INSTALLATION )
   Fig 4: Identifying Navigation ECU Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. INSTALL FRONT DOOR OPENING TRIM COVER RH  (See INSTALLATION )
9. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
11. INSTALL CONSOLE UPPER PANEL ASSEMBLY  (See INSTALLATION )
12. INSTALL FRONT CONSOLE UPPER PANEL GARNISH  (See INSTALLATION )
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
14. PERFORM INITIALIZATION 
    1. Perform initialization (See INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
15. CHECK SRS WARNING LIGHT 
    1. Check SRS warning light (See PRECAUTION ).