Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the CRUISE main indicator light by performing the Active Test.

   Combination Meter: 

   TESTER DISPLAY REFERENCE CHART
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp Cruise	Turns CRUISE main indicator light	ON / OFF	-

   OK: 

   Indicator light comes on/goes off. 

NG :  GO TO COMBINATION METER SYSTEM

OK : Go to next step. 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Radar Cruise / Data List.
5. Check the Data List for proper functioning of the CRUISE main indicator light.

   ECM (Radar Cruise): 

   MEASUREMENT ITEM/RANGE CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS Ready M-CPU	Cruise control system standby condition (Main CPU) / ON or OFF	Each time main switch is pushed, ON/OFF changes	A
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU) / ON or OFF	ON : "CRUISE" on OFF: "CRUISE" off	B

   OK: 

   When the cruise control main switch operation is performed, the result will be same as above. 

   HINT:

   A is OK, but B is NG → DTC output or ECM failure

NG : REPLACE ECM 

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE