LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> GS 450h >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Hybrid Transaxle - Service Information >> Transmission Control Switch >> Removal

Transmission Control Switch: Removal

  1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
  2. REMOVE BATTERY SERVICE HOLE COVER LH  (See REMOVAL )
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL  (See REMOVAL )
  4. REMOVE SHIFT LEVER KNOB  (See REMOVAL  )
  5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH  (See REMOVAL )
  6. REMOVE UPPER CONSOLE PANEL ASSEMBLY  (See REMOVAL )
  7. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  8. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  9. REMOVE CONSOLE BOX PLATE  (See REMOVAL )
  10. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  11. REMOVE CONSOLE BOX ASSEMBLY  (See REMOVAL )
  12. REMOVE NO. 2 CONSOLE BOX DUCT  (See REMOVAL )
  13. REMOVE HEATED OXYGEN SENSOR 
    1. Remove the heated oxygen sensor (See REMOVAL ).
  14. REMOVE FRONT FLOOR BRACE CENTER  (See REMOVAL )
  15. REMOVE REAR FLOOR NO. 1 PANEL BRACE  (See REMOVAL )
  16. REMOVE FRONT EXHAUST PIPE ASSEMBLY  (See REMOVAL )
  17. REMOVE FRONT FLOOR COVER CENTER RH 
    1. Remove the 3 grommets, and front floor cover center RH.
      2. Fig 1: Locating Front Floor Cover Center Grommets
      G05818807Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR  (See REMOVAL )
  19. REMOVE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  (See REMOVAL  )
  20. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY  (See REMOVAL  )
  21. REMOVE TRANSMISSION CONTROL SWITCH 
    1. Remove the shift lock control ECU connector from the floor shift assembly.
      Fig 2: Locating Shift Lock Control ECU Connector
      G05818808Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the shift lever nut and lock pin from the floor shift assembly.
    3. Remove the shift lever guide housing from the floor shift assembly.
      NOTE: First remove the shift lever nut and lock pin, then disengage the 2 claws.
      Fig 3: Identifying Shift Lever Nut And Lock Pin
      G05818809Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the transmission control switch from the shift lever guide housing.
scientia non olet · About LEMON Manuals