Shift Lever Position Sensor: Installation

1. Install the shift lever position sensor to the transmission.
2. Temporarily install the 2 bolts.

   HINT:

   Fully tighten the bolts with the neutral alignment mark line aligned with the groove. [*1]

   Fig 1: Locating Shift Lever Position Sensor Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new lock washer and the nut.

   Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf) 

   Fig 2: Locating Lock Nut And Lock Washer

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily install the control shaft lever.

   HINT:

   Stake the claws of the nut stopper before fully tightening the nut. [*2]

   Fig 3: Locating Control Shaft Lever And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the control shaft lever counterclockwise until it stops. Next, turn the control shaft lever clockwise 2 notches to set it to the N position.
   Fig 4: Turning Control Shaft Lever

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the transmission control shaft lever.
   Fig 5: Locating Transmission Control Shaft Lever Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Align the neutral alignment mark line with the switch groove, and tighten the 2 adjusting bolts. [*1]

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   Fig 6: Aligning Neutral Alignment Mark Line With Switch Groove

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Using a screwdriver, bend the lock washer tabs to secure the nut.
   NOTE: Make sure that the nut is held firmly.
   Fig 7: Prying Out Lock Washer

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Install the transmission control shaft lever with the nut. [*2]

   Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf) 

   Fig 8: Locating Transmission Control Shaft Lever And Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Connect the shift lever position sensor connector.
    Fig 9: Locating Shift Lever Position Sensor Connector

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the oil cooler tube and 4 new gaskets with the 2 bolts.

   Torque: 28 N*m (280 kgf*cm, 20 ft.*lbf) 

2. Install the oil cooler tube with the bolt.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

   Fig 10: Locating Oil Cooler Tube Bolts And Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Secure the 2 hoses with the 2 clips.

(See INSTALLATION ).