Seat Belt Control Ecu: Installation

INSTALL SEAT BELT CONTROL ECU
1. Engage the claw to install the seat belt control ECU to the junction block assembly.
  NOTE: Do not use an ECU that has been dropped or subjected to a strong impact.
2. Install nut A.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 1: Locating Seat Belt Control ECU And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Temporarily install nut B.
4. Connect the connectors.
5. Engage the claw.
  
  Fig 2: Engaging Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Pass temporarily installed nut B through the body hole (on the left side of the luggage compartment) and slide the seat belt control ECU downward to position it together with the junction block assembly.
7. Pass the 2 bolts through the body holes and fully tighten the nuts in the order of D, C and B.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  HINT:
  
  Jiggle the seat belt control ECU to check for looseness.
  
  Fig 3: Identifying Seat Belt Control ECU, Nuts And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER (See INSTALLATION )
INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
INSTALL TOOL BOX
INSTALL LUGGAGE COMPARTMENT SIDE TRIM COVER
INSTALL BATTERY SERVICE HOLE COVER
INSTALL LUGGAGE COMPARTMENT FLOOR MAT