Floor Shift Assembly: Reassembly

WARNING: This page is about a different car, the 2008 Lexus GS 460. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION CONTROL SWITCH
1. Install the transmission control switch to the shift lever guide housing.
  NOTE: Securely engage the claws.
  
  Fig 1: Identifying Transmission Control Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
1. Apply MP grease to the hatched area of the shift lever guide housing as shown in the illustration.
  
  Fig 2: Identifying MP Grease Applying Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the shift lock control ECU sub-assembly with the 2 screws.
  
  Fig 3: Locating Shift Lock Control ECU Sub-Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the shift lever guide housing with the shift lever lock pin and a new shift lever nut.
  NOTE:
  - Install the shift lever nut and lock pin after first engaging the 2 claws.
  - Securely engage the claws.
    
    Fig 4: Identifying Shift Lever Nut And Lock Pin
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the transmission control switch connector to the floor shift assembly.
  
  Fig 5: Locating Shift Lock Control ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL POSITION INDICATOR SLIDE COVER
1. Install the No. 2 position indicator slide cover to the position indicator slide cover.
2. Install the position indicator slide cover to the lower position indicator housing.
  
  Fig 6: Identifying Position Indicator Slide Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL POSITION INDICATOR LENS
1. Install the position indicator lens to the lower position indicator housing.
  NOTE: Securely engage the claws.
INSTALL SHIFT LEVER CAP
1. Install the shift lever cap to the position indicator housing.
  
  Fig 7: Identifying Position Indicator Lens
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL POSITION INDICATOR HOUSING
1. Install the position indicator housing to the lower position indicator housing.
  NOTE: Securely engage the claws.
  
  Fig 8: Locating Position Indicator Housing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY
1. Securely connect the 2 terminals of the indicator light wire harness to the transmission control switch connector.
  
  Fig 9: Removing Locking Lug Of Terminals
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the position indicator light bulb to the indicator light wire sub-assembly.
3. Install the position indicator bulb cap to the position indicator light bulb.
  
  Fig 10: Identifying Position Indicator Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the indicator light wire to the position indicator.
  NOTE: Make sure that the indicator light wire is securely installed to the position indicator.
  
  Fig 11: Installing Indicator Light Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHIFT POSITION INDICATOR
1. Install the shift position indicator to the upper console panel assembly with the 2 screws.
  HINT:
  
  Engage the 3 claws to install the indicator.
  
  Fig 12: Locating Shift Position Indicator Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the indicator light wire harness connector and the wire harness to the upper console panel assembly.
  
  Fig 13: Locating Indicator Light Wire Harness Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002