Actuator Check

ACTUATOR CHECK

Start the engine and warm it up.
Perform the indicator check (See CHECK MODE PROCEDURE ).
Push the "R/F" switch to perform the actuator check.
HINT:

Be sure to perform the actuator check after starting the engine.

Fig 1: Locating R/F Switch
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

As the actuator check is repeated from steps 1 to 10 at 1-second intervals, check the temperature and air flow visually and by hand.

HINT:

The display blinks at 1-second intervals in the step operation.
Push the "OFF" switch to finish panel diagnosis.

Push the "AUTO" switch to enter the sensor check mode.

Fig 2: Identifying Display Code

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISPLAY CODE CONDITION CHART

Step No.	Display Code	Conditions
Step No.	Display Code	Blower Level	Air Mix Damper	Airflow Vent	Air Inlet Damper	Compressor
1	0	0	0% open	FACE	FRESH	OFF
2	1	1	0% open	FACE	FRESH	OFF
3	2	17	0% open	FACE	RECIRCULATION / FRESH	ON
4	3	17	0% open	FACE	RECIRCULATION	ON
5	4	17	50% open	B/L	RECIRCULATION	ON
6	5	17	50% open	B/L	RECIRCULATION	ON
7	6	17	50% open	FOOT	FRESH	ON
8	7	17	100% open	FOOT-0	FRESH	ON
9	8	17	100% open	F/D	FRESH	ON
10	9	31	100% open	DEF	FRESH	ON

If the steps are difficult to read because they change automatically, push the "UPDr" switch to display the steps one at a time so that they can be read easily. The items are displayed step by step each time the "UPDr" switch is pushed.
HINT:
- Push the "OFF" switch to finish panel diagnosis.
- Push the "R/F" switch to enter the sensor check mode.
  
  Fig 3: Locating UPDr Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002