LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> ES 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Brake Control) >> Yaw Rate And Acceleration Sensor >> Removal

Yaw Rate And Acceleration Sensor: Removal

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY WITH FRONT ASH RECEPTACLE  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL FINISH END PANEL LH  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH END PANEL RH  (See REMOVAL )
  6. REMOVE CONSOLE POCKET  (See REMOVAL )
  7. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  8. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE REAR CONSOLE BOX ASSEMBLY  (See REMOVAL )
  10. REMOVE NO. 3 CONSOLE BOX DUCT  (See REMOVAL )
  11. REMOVE YAW RATE AND ACCELERATION SENSOR 
    1. Disconnect the yaw rate sensor connector and clamp.
    2. Remove the 2 bolts and yaw rate sensor.
      NOTE: Do not remove the sensor from the bracket.
    Fig 1: Locating Yaw Rate Sensor Connector And Bolts
    G05250504Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals