Front Bumper: Installation

INSTALL FRONT BUMPER ASSEMBLY
1. Connect each connector.
2. Engage each claw.
3. Install the front bumper assembly with the 9 screws, 2 clips, 2 radiator grille protectors and bolt.
  Torque: Screw (A)
  
  2.0 N*m (20 kgf*cm, 18 in.*lbf)
  
  Fig 1: Identifying Front Bumper Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 2 pin hold clips.
  HINT:
  
  Use the same procedures for the RH side and LH side.
  
  Fig 2: Installing Pin Hold Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOL AIR INTAKE DUCT SEAL
1. Install the cool air intake duct seal with the 7 clips.
Fig 3: Identifying Cool Air Intake Duct Seal Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
VEHICLE PREPARATION FOR FOG LIGHT AIMING (See REMOVAL )
PREPARATION FOR FOG LIGHT AIMING (See ADJUSTMENT )
INSPECT FOG LIGHT AIMING (See ADJUSTMENT )
ADJUST FOG LIGHT AIMING (See ADJUSTMENT )