Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Check the CRUISE main indicator light by performing ACTIVE TEST.

   Combination meter 

   DATA LIST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   CRUISE INDIC	Turns CRUISE main indicator light	ON / OFF	-

   OK: Indicator light comes on / goes off. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL )

OK: Go to Next Step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG) and turn the Techstream main switch on.
3. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

   ECM (Cruise control): 

   DATA LIST
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CRUISE" on OFF: "CRUISE" off	-

   OK: When the cruise control main switch is operated, the display changes as shown above. 

NG: REPLACE ECM  (See REMOVAL )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE