Headlight Assembly: Removal

HINT:

• Use the same procedures for the RH and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE RADIATOR GRILLE (See  REMOVAL  ) 
3. REMOVE FRONT FENDER LINER LH (See  REMOVAL  ) 
4. REMOVE FRONT FENDER LINER RH (See  REMOVAL  ) 
5. REMOVE FRONT BUMPER ENERGY ABSORBER 
6. REMOVE FRONT BUMPER COVER (See  REMOVAL  ) 
7. REMOVE HEADLIGHT ASSEMBLY 
   1. Remove the 2 bolts, nut and clip.
   2. Disconnect the connectors.
      Fig 1: Identifying Headlight Assembly Bolts And Clip

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Pull out the unit in the direction indicated by the arrow in the illustration.