Inspection Procedure

1. Disconnect the R3 receiver connector.
   Fig 1: Identifying R3 Receiver Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the S23 amplifier connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition
   R3-8 (R+) - S23-11 (R+)	Below 1 Ω
   R3-9 (L+) - S23-12 (L+)	Below 1 Ω
   R3-18 (R-) - S23-23 (R-)	Below 1 Ω
   R3-19 (L-) - S23-24 (L-)	Below 1 Ω
   R3-8 (R+) or S23-11 (R+) - Body ground	10 kΩ or higher
   R3-9 (L+) or S23-12 (L+) - Body ground	10 kΩ or higher
   R3-18 (R-) or S23-23 (R-) - Body ground	10 kΩ or higher
   R3-19 (L-) or S23-24 (L-) - Body ground	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE