Throttle Body: Removal

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
DRAIN ENGINE COOLANT (See REPLACEMENT )
REMOVE V-BANK COVER
1. Remove the 2 nuts, then remove the V-bank cover.
  
  Fig 1: Identifying V-Bank Cover Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR CLEANER ASSEMBLY
1. Disconnect the No. 2 ventilation hose.
  
  Fig 2: Identifying Ventilation Hose No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the vacuum hose.
3. Disconnect the mass air flow meter connector.
4. Disengage the 2 wire harness clamps.
  
  Fig 3: Identifying Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Loosen the 2 hose clamps.
6. Remove the 2 bolts.
7. Disconnect the air cleaner hose and remove the air cleaner.
REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
1. Disconnect the No. 5 water by-pass hose.
2. Disconnect the No. 4 water by-pass hose.
3. Disconnect the throttle motor connector.
4. Remove the 4 bolts, then remove the throttle w/ motor body and gasket.
5. Remove the No. 5 water by-pass hose.
6. Remove the No. 4 water by-passe hose.