Side Airbag Sensor: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures described below are for the LH side.

1. PRECAUTION 
   CAUTION: Read PRECAUTION  thoroughly before servicing .
2. INSTALL SIDE AIRBAG SENSOR LH 
   1. Check that the ignition switch is turned to OFF.
   2. Check that the negative (-) battery terminal is disconnected.
      CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
   3. Install the side airbag sensor LH with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      NOTE:

      • If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
      • When installing the side airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.
   4. Check that there is no looseness in the installation parts of the side airbag sensor LH.
      Fig 1: Identifying Side Airbag Sensor LH Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   5. Connect the connector to the side airbag sensor LH.
3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
4. INSTALL ACCESS DOOR SCUFF PLATE LH  (See INSTALLATION )
5. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

   Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

7. PERFORM INITIALIZATION 
   1. Perform INITIALIZATION .

      HINT:

      Some systems need initialization when the cable has been disconnected from the negative battery terminal.

      Fig 2: Identifying Side Airbag Sensor LH Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. INSPECT SRS WARNING LIGHT 
   1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM  ).