LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (Supplemental Restraint System) >> Center Airbag Sensor Assembly >> Installation

Center Airbag Sensor Assembly: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    CAUTION: Read PRECAUTION  thoroughly before servicing .
  2. INSTALL CENTER AIRBAG SENSOR ASSEMBLY 
    1. Check that the ignition switch is turned to OFF.
    2. Check that the negative (-) battery terminal is disconnected.
      NOTE: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
    3. Temporarily install the center airbag sensor assembly with the 3 bolts.
      NOTE:
      • If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
      • When installing the center airbag sensor assembly, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched between other parts.
    4. Tighten the 3 bolts to the specified torque.

      Torque: 17.5 N*m (179 kgf*cm, 13 ft.*lbf) 

      Fig 1: Identifying Center Airbag Sensor Assembly Bolts
      G05113321Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Check that there is no looseness in the installation parts of the center airbag sensor assembly.
    6. Connect the holder (with connectors) to the center airbag sensor assembly.
      Fig 2: Identifying Holder
      G05113323Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Check that the water-proof sheet is properly set.
  3. INSTALL INSTRUMENT LOWER COVER SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL CONSOLE UPPER PANEL NO.1 GARNISH  (See INSTALLATION )
  5. INSTALL FRONT CONSOLE BOX  (See INSTALLATION )
  6. INSTALL BOX BOTTOM MAT  (See INSTALLATION )
  7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)  (See INSTALLATION )
  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  (See INSTALLATION )
  11. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY  (See INSTALLATION )
  12. INSTALL INSTRUMENT PANEL GARNISH RH  (See INSTALLATION )
  13. INSTALL INSTRUMENT PANEL GARNISH LH  (See INSTALLATION )
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  15. PERFORM INITIALIZATION 
    1. Perform INITIALIZATION .

      HINT:

      Some systems need initialization after reconnecting the cable to the negative battery terminal.

  16. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals