Section 278 (Charging System): Generator: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Install the generator assembly with the 2 bolts.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  Fig 1: Identifying Generator Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the wire harness clamp bracket with the 2 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 2: Identifying Wire Harness Clamp Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the wire harness.
  1. Connect the wire harness to terminal B and install the nut.
    Torque: 10 N*m (100 kgf*cm, 7 ft.*lbf)
  2. Connect the connector to the generator assembly.
    
    Fig 3: Identifying Terminal Cap & Nut
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Install the wire harness stay with the bolt.
    Torque: 5.8 N*m (59 kgf*cm, 51 in.*lbf)
    
    Fig 4: Identifying Wire Harness Stay
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL NO. 1 UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER (See INSTALLATION )
INSTALL BATTERY
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)