Inspection Procedure
HINT:
The SLIP indicator light comes on when the traction control switch is ON.
- INSPECT CAN COMMUNICATION SYSTEM
- Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).
Result
RESULT CHARTCondition Proceed To DTC is not output A DTC is output B B: REPAIR CAN COMMUNICATION SYSTEM
A: Go to next step
- INSPECT MULTIPLEX COMMUNICATION SYSTEM
- Check if the multiplex communication system DTC is output (See DTC CHECK / CLEAR ).
Result
RESULT CHARTCondition Proceed To DTC is not output A DTC is output B B: REPAIR MULTIPLEX COMMUNICATION SYSTEM
A: Go to next step
- INSPECT SLIP INDICATOR LIGHT
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch on.
- Select the "SLIP INDI LAMP" in the ACTIVE TEST and operate the SLIP indicator light using the intelligent tester.
ABS/VSC/TRAC:
VEHICLE CONDITION DIAGNOSTIC CHARTItem (Display) Vehicle Condition/ Test Details Diagnostic Note SLIP INDI LAMP Turn SLIP indicator light ON/OFF Observe combination meter - Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using the intelligent tester.
OK: The SLIP indicator light turns on or off in accordance with the operating using the intelligent tester.
HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE ).
OK: REPLACE SKID CONTROL ECU
NG: Go to next step
- INSPECT COMBINATION METER ASSEMBLY
- Check the combination meter assembly (See
HOW TO PROCEED WITH TROUBLESHOOTING
).
HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step (See PROBLEM SYMPTOMS TABLE ).
NG: REPLACE COMBINATION METER ASSEMBLY
OK: END
- Check the combination meter assembly (See
HOW TO PROCEED WITH TROUBLESHOOTING
).