LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 307 (Brake Control System) >> Yaw Rate And Deceleration Sensor >> Removal

Yaw Rate And Deceleration Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  (See REMOVAL )
  5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE YAW RATE AND DECELERATION SENSOR 
    1. Disconnect the yaw rate and deceleration sensor connector.
      2. Fig 1: Identifying Yaw Rate And Deceleration Sensor Connector And Bolts
      G05112388Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and remove the yaw rate and deceleration sensor.
scientia non olet · About LEMON Manuals