Rear Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR SPEED SENSOR
1. Install the rear speed sensor with the nut.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
  
  NOTE: Make sure that the sensor tip is clean.
  
  Fig 1: Identifying Rear Speed Sensor Wire Connector And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the skid control sensor wire.
INSTALL REAR WHEEL
Torque: 112 N*m (1,137 kgf*cm, 82 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
CHECK VSC SENSOR SIGNAL
(See TEST MODE PROCEDURE )