Section 277 (Starting System): Starter: Installation

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STARTER ASSEMBLY
1. Install the starter assembly with 2 bolts.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
  
  Fig 1: Identifying Starter Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the wire harness to the terminal 30, then install the nut.
  Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf)
  
  Fig 2: Connecting Wire Harness To Terminal 30
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the terminal 50 connector to the starter assembly.
INSTALL WIRE HARNESS
1. Install the wire harness onto the cylinder block with the bolt.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
  
  Fig 3: Identifying Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO.2 EXHAUST MANIFOLD STAY
1. Install the No. 2 manifold stay with the 3 bolts.
  Torque: 40 N*m (408 kgf*cm, 30 in.*lbf)
  
  Fig 4: Identifying No. 2 Exhaust Manifold Stay Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO.2 ENGINE UNDER COVER ASSEMBLY
1. Install the No. 2 engine under cover with the 4 bolts.
  Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)