Section 257 (Charging System): Generator: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Provisionally install the generator with fixing bolt B.
  
  Fig 1: Locating Generator Fixing Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Provisionally install the fan belt adjusting slider with fan belt adjusting slider fixing bolts A and B, then move the generator toward the cylinder block and tighten bolt B.
  Torque: 11 N*m (112 kgf*cm, 8.1 ft.*lbf)
  
  Fig 2: Locating Fan Belt Adjusting Slider Fixing Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the connector and the wire harness clamp.
4. Install terminal B with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 7.2 ft.*lbf)
5. Install the terminal cap.
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
ADJUST FAN AND GENERATOR V BELT (See INSTALLATION )
INSPECT FAN AND GENERATOR V BELT (See INSTALLATION )

Fig 3: Locating Connector & Harness Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ENGINE UNDER COVER RH
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)