Seat Position Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).

INSTALL SEAT POSITION AIRBAG SENSOR
1. Using a 1 mm (0.039 in.) feeler gauge, install the seat position sensor.
  NOTE:
  - If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
  - When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
  Fig 1: Identifying Seat Slide Position Sensor Protector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
2. Using a T30 "Torx" socket, tighten the "Torx" screw to install the seat position sensor.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
3. Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm to 1.4 mm (0.023 to 0.055 in.).
4. Connect the connector.
5. Install the seat slide position sensor protector to the seat position sensor.
INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) (see INSTALLATION )
INSTALL FRONT SEAT ASSEMBLY (for Power Seat) (see INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see PROBLEM SYMPTOMS TABLE ).
Fig 2: Identifying Seat Slide Position Sensor Protector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002