LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Windshield / WINDOWGLASS >> Rear Quarter Window Class >> Removal

Rear Quarter Window Class: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation (See AIRBAG SYSTEM ).
  2. REMOVE REAR DOOR SCUFF PLATE LH  (See REMOVAL )
  3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 
  4. REMOVE DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE TONNEAU COVER ASSEMBLY 
  6. REMOVE DECK FLOOR BOX FRONT  (See REMOVAL )
  7. REMOVE DECK FLOOR BOX REAR  (See REMOVAL )
  8. REMOVE NO.2 DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE NO.3 DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE BACK DOOR WEATHERSTRIP 
  11. REMOVE JACK CARRIER ASSEMBLY 
  12. REMOVE DECK SIDE TRIM BOX RH 
  13. REMOVE DECK SIDE TRIM BOX LH  (See REMOVAL )
  14. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  15. REMOVE REAR FLOOR FINISH SIDE PLATE LH  (See REMOVAL )
  16. REMOVE DECK SIDE TRIM COVER LH  (See REMOVAL )
  17. SEPARATE REAR NO.1 SEAT BELT ASSEMBLY OUTER LH  (See REMOVAL )
  18. REMOVE REAR SEAT SIDE COVER LH  (See REMOVAL )
  19. REMOVE ROPE HOOK  (See REMOVAL )
  20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH  (See REMOVAL )
  21. REMOVE NO.2 ROOM LIGHT ASSEMBLY  (See REMOVAL )
  22. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER LH  (See REMOVAL )
  23. REMOVE QUARTER WINDOW ASSEMBLY LH 
    1. Pass a piano wire between the vehicle body and glass from the interior.
      Fig 1: Identifying Piano Wire Between Vehicle Body And Glass
      G05281115Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Tie both wire ends to wooden blocks or similar objects.
      NOTE: When separating the glass, take care not to damage the paint and the interior and exterior ornaments.
      Fig 2: Identifying Protective Tape On Outer Surface
      G05281116Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Apply protective tape to the outer surface to prevent the surface from being scratched.

    3. Cut off the adhesive by pulling the piano wire around the glass.
    4. Using a suction cup, remove the glass.
      NOTE: Leave as much adhesive on the vehicle body as possible when removing the glass.
  24. CLEAN QUARTER WINDOW ASSEMBLY LH 
    1. Clean the outer circumference of the glass with white gasoline.
      NOTE:
      • Do not touch the glass surface after cleaning it.
      • Be careful not to damage the glass.