Rear Cooler Control Panel: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

HINT:

At the time of installation, perform initialization (see INITIALIZATION ).

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
REMOVE REAR HEATER CONTROL ASSEMBLY
1. Using a screwdriver, detach the 4 claws and pull out the rear heater control, and then disconnect the connector.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Removing Rear Heater Control Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002