Data List / Active Test

HINT:

Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the ignition switch ON.
3. Read the DATA LIST by following the directions on the tester screen.

   Transponder key ECU assembly: 

   DATA LIST - TRANSPONDER KEY ECU ASSEMBLY
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   IG SW	Ignition switch signal / ON or OFF	OFF: Ignition switch OFF or ACC ON: Ignition switch ON
   KEY SW	Unlock warning switch signal / ON or OFF	OFF: No key is in ignition key cylinder ON: Key is in ignition key cylinder
   +B	+B judgment / NORMAL or BREAK	NORMAL: Battery supply is normal BREAK: Battery supply is malfunctioning
   ANTENNA COIL	Transponder key coil condition / NORMAL or FAIL	NORMAL: Transponder key coil is normal FAIL: Transponder key coil is malfunctioning
   IMMOBILISER	Immobiliser system status / SET or UNSET	UNSET: Ignition switch ON SET: No key is in ignition key cylinder
   MASTER KEY	Master key code signal / NOMATCH or MATCH	NOMATCH: Unmatched master key code is sent MATCH: Registered master key code is sent
   SUB KEY	Sub-key code signal / NO MATCH or MATCH	NOMATCH: Unmatched sub-key code is sent MATCH: Registered sub-key code is sent
   BCC	Transponder chip signal / NG or OK	NG: Incorrect data sent OK: Correct data sent
   ENCRYPT CODE	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   SERIAL NUMBER	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   FRAME	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   RESPONSE	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   REG CODE SPACE	Memory space for key codes registration/ NOT FUL or FULL	NOT FUL: Possible to register more key codes FULL: Cannot register any more key codes
   REGIST SUB CODE	Number of registered sub-key/ min. 0, max. 15	Number of registered sub-keys
   REGIST MAS CODE	Number of registered master key/ min. 0, max. 15	Number of registered master keys
   G-CODE SUPPORT	-	NOT SUP: G-code is not supported SUPPORT: G-code is supported

HINT:

Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The Data List can be displayed during the ACTIVE TEST.

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the ignition switch ON.
3. Perform the ACTIVE TEST by following the directions on the tester screen.

   Transponder key ECU assembly: 

   ACTIVE TEST LIST - TRANSPONDER KEY ECU ASSEMBLY
   
   

   Item	Test Details	Diagnostic Note
   SECURITY INDIC	Turn security indicator ON/OFF	-